MAXTRAX MOUNTING PIN SET

It’s important to get the holes in just the right spot, as they fit very snug.. if you are 3 mm out say, then they won’t want to go on..

So measure carefully, drill holes, and just bolt them on.. best to mount to a scrap piece of board, like some ply, test fit, if correct, use the board as the stencil to mark the holes..

This is shown with one set only, so will hold a second set no worries..

But, if they are full of mud etc, then you won’t be able to fit 2 pair.. one pair would still be fine..

You can buy this small wire lock from woollies.. it’s handy to use, you don’t want people to nick your maxtrax..

So this is the kit.. for the right application, they are very handy…